Net-tools to iproute2: Difference between revisions
From Leo's Notes
This page was last edited on 24 February 2017, at 19:14.
m Text replacement - "<code>" to "{{code|" |
m Text replacement - "</code>" to "}}" |
||
| Line 25: | Line 25: | ||
|} | |} | ||
Like networking commands on switches and routers, you do not need to write the full command name so long as the beginning of the command is uniquely identifiable. For example, {{code|ip address | Like networking commands on switches and routers, you do not need to write the full command name so long as the beginning of the command is uniquely identifiable. For example, {{code|ip address}} can be simplified to {{code|ip a}} and {{code|ip route}} can be simplified to {{code|ip r}}. | ||
The {{code|ip address add $ip/$mask dev $interface | The {{code|ip address add $ip/$mask dev $interface}} will add additional IP addresses to the device. If it already has an existing IP address, you will need to use {{code|ip address del $ip/$mask dev $interface}} to remove it. | ||
Some other commands: | Some other commands: | ||
Revision as of 19:14, 24 February 2017
The following maps the deprecated network tools (ifconfig, route, netstat, etc) to the new ip command.
| Old | New |
|---|---|
| ifconfig | ip addr |
| ifconfig $interface [up|down] | ip link set dev $interface [up|down] |
| ifconfig $interface $ip netmask $netmask | ip addr add $ip/$mask dev $interface |
| route add default gw $gateway | ip route add default via $gateway |
| route add -net $net netmask $netmask gw $gateway | ip route add $net/$mask via $gateway |
| route -n | ip route |
Like networking commands on switches and routers, you do not need to write the full command name so long as the beginning of the command is uniquely identifiable. For example, ip address can be simplified to ip a and ip route can be simplified to ip r.
The ip address add $ip/$mask dev $interface will add additional IP addresses to the device. If it already has an existing IP address, you will need to use ip address del $ip/$mask dev $interface to remove it.
Some other commands: