Driver Disk: Difference between revisions
From Leo's Notes
This page was last edited on 1 September 2019, at 05:09.
m Text replacement - "</code>" to "}}" |
m Text replacement - "Category:Linux" to "Category:Linux{{Navbox Linux}}" |
||
| Line 18: | Line 18: | ||
Once you have the driver disk created, you will need to tell the installer to load it by booting into {{code|linux expert}} or {{code|linux dd}} from the boot loader. | Once you have the driver disk created, you will need to tell the installer to load it by booting into {{code|linux expert}} or {{code|linux dd}} from the boot loader. | ||
[[Category:Linux]] | [[Category:Linux]]{{Navbox Linux}} | ||
Revision as of 05:09, 1 September 2019
Red Hat allows for 'driver disks' to be loaded during an install in case there is no out-of-the-box driver support for a specific piece of hardware. Basically, a driver disk is an ext2 disk image which can be created in the following steps:
Create Driver Disk
# Create a blank, 20MB image
dd if=/dev/zero of=driverdisk.img bs=1M count=20
# Format the image with ext2
mkfs -t ext2 -q driverdisk.img
# mount it and copy the files over
mount -o loop driverdisk.img /mnt/driverdisk
# copy drivers to /mnt/driverdisk, then run
umount /mnt/tmp
Once you have the driver disk created, you will need to tell the installer to load it by booting into linux expert or linux dd from the boot loader.