Arduino

From Leo's Notes
This page was last edited on 28 February 2017, at 18:37.

Programming the Arduino Mini/Nano

Arduino Uno/Duemilanove to Mini Connection

You can use a regular Arduino Uno or Duemilanove to program an Arduino Mini. To do so:

  1. Connect GND and VCC from the Arduino Uno/Duemilanove to the Arduino Mini/Nano
  2. Pull the Atmega 328 microprocessor from socket on the Arduino Uno/Duemilanove
  3. Connect RX (Pin 0) and TX (Pin 1) from the Arduino Uno/Duemilanove to RXI and TXO pins on the Arduino Mini/Nano respectively.

Then program the Arduino as you normally would while making sure that the board selected in the Arduino IDE is set to the Arduino Mini or Nano.