Setup University of Calgary Printers

From Leo's Notes
Revision as of 22:49, 22 August 2023 by Leo (talk | contribs) (Created page with "The University of Calgary's managed IT printers are all Ricoh C4510 printers. The printers should be preconfigured on all managed IT computers but if you use a self-managed machine, you will have to set up the printers manually. == How to install Ricoh C4510 on Linux == Download the C4510 ppd file from: https://www.openprinting.org/download/PPD/Ricoh/PDF/Ricoh-IM_C4510_PDF.ppd === Required software === You will need to install the system-config-printer package. ==== F...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
This page was last edited on 22 August 2023, at 22:49.

The University of Calgary's managed IT printers are all Ricoh C4510 printers. The printers should be preconfigured on all managed IT computers but if you use a self-managed machine, you will have to set up the printers manually.

How to install Ricoh C4510 on Linux

Download the C4510 ppd file from: https://www.openprinting.org/download/PPD/Ricoh/PDF/Ricoh-IM_C4510_PDF.ppd

Required software

You will need to install the system-config-printer package.

Fedora / Red Hat

Install the following packages: dnf -y install system-config-printer cups-client samba-client

Ubuntu / Debian-based

Install the following packages: apt install system-config-printer cups-client smbclient samba

NixOS

Add in the system-config-printer package to your systemPackages list.

Add the printer queue

Run system-config-printer from the Terminal

Click on 'Add' and select 'Network Printer -> Find Network Printer -> Windows Printer via SAMBA'.

In the SMB Printer dialog:

  • Enter smb://itctspcp01.uc.ucalgary.ca/Staff. If you are a student, you must use the Student queue (cost per use applies) smb://uc/itctspcp06.uc.ucalgary.ca/Student.
  • Select 'Prompt user if authentication is required'

Next, when asked to choose a driver, specify the PPD file that you downloaded for the C4510.

Configure the printer with 'Finisher SR3310' and no other installable options.

Do not print a test page. Instead, finish the setup first and then submit a test page. This is because you need to authenticate for the print job to submit properly which won't happen until you finish the printer setup.

After you submit a print job, open the print queue and click on 'Authenticate'. When prompted to log in, enter your UCIT credentials. If authentication fails, try adding a 'uc/' prefixed to your username (Eg. 'uc/username').

See also