Arduino: Difference between revisions
From Leo's Notes
This page was last edited on 28 February 2017, at 18:37.
| Line 1: | Line 1: | ||
== Programming the Arduino Mini == | == Programming the Arduino Mini/Nano == | ||
[[File:Arduino_Uno_to_Mini_Connection.png|350px|thumb|right|Arduino Uno/Duemilanove to Mini Connection]] | [[File:Arduino_Uno_to_Mini_Connection.png|350px|thumb|right|Arduino Uno/Duemilanove to Mini Connection]] | ||
You can use a regular Arduino Uno or Duemilanove to program an Arduino Mini. To do so: | You can use a regular Arduino Uno or Duemilanove to program an Arduino Mini. To do so: | ||
# Connect GND and VCC from the Arduino Uno to the Arduino Mini | # Connect GND and VCC from the Arduino Uno/Duemilanove to the Arduino Mini/Nano | ||
# Pull the Atmega 328 from the Arduino Uno | # Pull the Atmega 328 microprocessor from socket on the Arduino Uno/Duemilanove | ||
# Connect RX (Pin 0) and TX (Pin 1) from the Arduino Uno to the Arduino Mini | # Connect RX (Pin 0) and TX (Pin 1) from the Arduino Uno/Duemilanove to RXI and TXO pins on the Arduino Mini/Nano respectively. | ||
Then program the Arduino as you normally would while making sure that the board selected in the Arduino IDE is set to the Arduino Mini. | Then program the Arduino as you normally would while making sure that the board selected in the Arduino IDE is set to the Arduino Mini or Nano. | ||
Revision as of 18:37, 28 February 2017
Programming the Arduino Mini/Nano

You can use a regular Arduino Uno or Duemilanove to program an Arduino Mini. To do so:
- Connect GND and VCC from the Arduino Uno/Duemilanove to the Arduino Mini/Nano
- Pull the Atmega 328 microprocessor from socket on the Arduino Uno/Duemilanove
- Connect RX (Pin 0) and TX (Pin 1) from the Arduino Uno/Duemilanove to RXI and TXO pins on the Arduino Mini/Nano respectively.
Then program the Arduino as you normally would while making sure that the board selected in the Arduino IDE is set to the Arduino Mini or Nano.