Arduino: Difference between revisions

From Leo's Notes
This page was last edited on 28 February 2017, at 18:37.
Line 1: Line 1:
== Programming the Arduino Mini ==
== Programming the Arduino Mini/Nano ==
[[File:Arduino_Uno_to_Mini_Connection.png|350px|thumb|right|Arduino Uno/Duemilanove to Mini Connection]]
[[File:Arduino_Uno_to_Mini_Connection.png|350px|thumb|right|Arduino Uno/Duemilanove to Mini Connection]]
You can use a regular Arduino Uno or Duemilanove to program an Arduino Mini. To do so:
You can use a regular Arduino Uno or Duemilanove to program an Arduino Mini. To do so:


# Connect GND and VCC from the Arduino Uno to the Arduino Mini
# Connect GND and VCC from the Arduino Uno/Duemilanove to the Arduino Mini/Nano
# Pull the Atmega 328 from the Arduino Uno
# Pull the Atmega 328 microprocessor from socket on the Arduino Uno/Duemilanove
# Connect RX (Pin 0) and TX (Pin 1) from the Arduino Uno to the Arduino Mini
# Connect RX (Pin 0) and TX (Pin 1) from the Arduino Uno/Duemilanove to RXI and TXO pins on the Arduino Mini/Nano respectively.


Then program the Arduino as you normally would while making sure that the board selected in the Arduino IDE is set to the Arduino Mini.
Then program the Arduino as you normally would while making sure that the board selected in the Arduino IDE is set to the Arduino Mini or Nano.

Revision as of 18:37, 28 February 2017

Programming the Arduino Mini/Nano

Arduino Uno/Duemilanove to Mini Connection

You can use a regular Arduino Uno or Duemilanove to program an Arduino Mini. To do so:

  1. Connect GND and VCC from the Arduino Uno/Duemilanove to the Arduino Mini/Nano
  2. Pull the Atmega 328 microprocessor from socket on the Arduino Uno/Duemilanove
  3. Connect RX (Pin 0) and TX (Pin 1) from the Arduino Uno/Duemilanove to RXI and TXO pins on the Arduino Mini/Nano respectively.

Then program the Arduino as you normally would while making sure that the board selected in the Arduino IDE is set to the Arduino Mini or Nano.