Link Aggregation

Network bonding joins two or more network interfaces together, also known as link aggregation. Depending on the configuration, you can increase bandwidth, throughput, performance and redundancy.

Linux

There is a bonding kernel module which can bond multiple network interfaces into a virtual bonded network interface. There are a few modes that are supported:

Type	Description
mode=0, mode=balance-rr	Round Robin policy and is the default mode.
mode=1, mode=active-backup	Only one slave is active at one time. All slave interfaces will share the same MAC address.
mode=3, mode=broadcast	Everything is transmitted on all slave interfaces
mode=4, mode=802.3ad	Dynamic Link Aggregation mode on a switch that supports IEEE 802.3ad dynamic link.
mode=5, mode=balance-tlb	Adaptive transmit load balancing. Outgoing traffic is distributed based on load on each slave.
mode=6, mode=balance-alb	Adaptive load balancing.

You can see the current bonding status by reading /proc/net/bonding/bond0:

# cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011)
 
Bonding Mode: fault-tolerance (active-backup) (fail_over_mac active)
Primary Slave: None
Currently Active Slave: ib2
MII Status: up
MII Polling Interval (ms): 100
Up Delay (ms): 0
Down Delay (ms): 0
 
Slave Interface: ib0
MII Status: up
Speed: 56000 Mbps
Duplex: full
Link Failure Count: 2
Permanent HW addr: a0:00:00:2a:fe:80
Slave queue ID: 0
 
Slave Interface: ib1
MII Status: up
Speed: 56000 Mbps
Duplex: full
Link Failure Count: 1
Permanent HW addr: a0:00:00:2c:fe:80
Slave queue ID: 0
 
Slave Interface: ib2
MII Status: up
Speed: 56000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: a0:00:00:2a:fe:80
Slave queue ID: 0
 
Slave Interface: ib3
MII Status: up
Speed: 56000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: a0:00:00:2c:fe:80
Slave queue ID: 0

See Also

• http://www.linuxhorizon.ro/bonding.html
• https://wiki.debian.org/Bonding
• https://www.interserver.net/tips/kb/network-bonding-types-network-bonding/