Troubleshooting[edit | edit source]

Compiling on CentOS 5[edit | edit source]

WordPress content from February 27, 2012

If you tried compiling the latest version of streamripper (1.64.6), you'll probably see the following error:

$ ./configure
< Snip > 
*** Could not run GLIB test program, checking why...
*** The test program failed to compile or link. See the file config.log for the
*** exact error that occured. This usually means GLIB is incorrectly installed.
configure: error: Glib 2.16 or greater required

If so, try using an older version such as 1.62.0:

$ cd streamripper-1.62.0
$ ./configure
$ make
< Snip >
Making all in po
make[3]: Entering directory `/home/leo/streamrip/streamripper-1.62.0/tre-0.7.2/po'
test -z "" || make
make[4]: Entering directory `/home/leo/streamrip/streamripper-1.62.0/tre-0.7.2/po'
rm -f && : -c --statistics -o fi.po
mv: cannot stat `': No such file or directory
make[4]: *** [] Error 1
make[4]: Leaving directory `/home/leo/streamrip/streamripper-1.62.0/tre-0.7.2/po'
make[3]: *** [stamp-po] Error 2
make[3]: Leaving directory `/home/leo/streamrip/streamripper-1.62.0/tre-0.7.2/po'
make[2]: *** [all-recursive] Error 1
make[2]: Leaving directory `/home/leo/streamrip/streamripper-1.62.0/tre-0.7.2'
make[1]: *** [all] Error 2
make[1]: Leaving directory `/home/leo/streamrip/streamripper-1.62.0/tre-0.7.2'
make: *** [all-recursive] Error 1

Try to configure with the ' --disable-adplug' flag.

$ ./configure --disable-adplug
$ make
$ make install