Anycubic Mega S: Difference between revisions
From Leo's Notes
This page was last edited on 19 September 2020, at 03:31.
Created page with "The Anycubic Mega S is a cheap 3D printer. I bought this printer for about $280 CAD with shipping. == Firmware == For an updated firmware, see: * https://github.com/knutwur..." |
No edit summary |
||
| Line 1: | Line 1: | ||
The Anycubic Mega S is a cheap 3D printer. I bought this printer for about $280 CAD with shipping. | The Anycubic Mega S is a cheap 3D printer. I bought this printer for about $280 CAD with shipping. | ||
== Firmware == | ==Firmware== | ||
For an updated firmware, see: | For an updated firmware, see: | ||
* https://github.com/knutwurst/Marlin-2-0-x-Anycubic-i3-MEGA-S | |||
*https://github.com/knutwurst/Marlin-2-0-x-Anycubic-i3-MEGA-S | |||
The stock firmware can be found on Anycubic's website, near the bottom of the page. | The stock firmware can be found on Anycubic's website, near the bottom of the page. | ||
== Mods == | *https://www.anycubic.com/products/anycubic-i3-mega-s?variant=32094219305091 | ||
* Filament Holder - https://www.thingiverse.com/thing:2841440 | |||
* TMC2208 V2 driver | ==Mods== | ||
*Filament Holder - https://www.thingiverse.com/thing:2841440 | |||
*TMC2208 V2 driver. I bought 5 TMC2208 V2 modules. | |||
*Y Belt Tensioner - https://www.thingiverse.com/thing:2789837 | |||
== See Also == | |||
* https://www.thingiverse.com/thing:2901190 - Goes over mods for the Anycubic i3 Mega. Some of the slicer settings may be of interest. | |||
Revision as of 03:31, 19 September 2020
The Anycubic Mega S is a cheap 3D printer. I bought this printer for about $280 CAD with shipping.
Firmware
For an updated firmware, see:
The stock firmware can be found on Anycubic's website, near the bottom of the page.
Mods
- Filament Holder - https://www.thingiverse.com/thing:2841440
- TMC2208 V2 driver. I bought 5 TMC2208 V2 modules.
- Y Belt Tensioner - https://www.thingiverse.com/thing:2789837
See Also
- https://www.thingiverse.com/thing:2901190 - Goes over mods for the Anycubic i3 Mega. Some of the slicer settings may be of interest.