Firewall - Revision history

Leo at 20:49, 16 May 2023

2023-05-16T20:49:10Z

@@ Line 2: / Line 2: @@
 Linux typically uses IPTables for its firewall. On most modern Linux distributions, IPTables is controlled through another program or manager such as firewalld, or CSF.
-=== Opening a Port ===
+=== Firewalld ===
 To allow a specific port access to your machine, you will (most likely) need to make IPTables {{code|ACCEPT}} traffic meeting the port criteria on the {{code|INPUT}} chain.
@@ Line 18: / Line 42: @@
 }}
 If using CSF:
 {{highlight|lang=terminal|code=

Leo: Added cateogry

2020-06-14T23:34:00Z

Added cateogry

← Older revision		Revision as of 23:34, 14 June 2020
Line 25:		Line 25:
	# csf -r		# csf -r
	}}		}}

			{{Navbox Linux}}[[Category:Linux]]
			[[Category:Networking]]

Leo: /* Opening a Port */

2019-10-09T20:04:10Z

Opening a Port

← Older revision		Revision as of 20:04, 9 October 2019
Line 3:		Line 3:

	=== Opening a Port ===		=== Opening a Port ===
	To allow a specific port access to your machine, you will (most likely) need to make IPTables ACCEPT traffic meeting the port criteria on the INPUT chain.		To allow a specific port access to your machine, you will (most likely) need to make IPTables {{code\|ACCEPT}} traffic meeting the port criteria on the {{code\|INPUT}} chain.

	Simple IPTables:		Simple IPTables:

Leo: Created page with "== Linux == Linux typically uses IPTables for its firewall. On most modern Linux distributions, IPTables is controlled through another program or manager such as firewalld, or..."

2019-10-09T20:03:32Z

Created page with "== Linux == Linux typically uses IPTables for its firewall. On most modern Linux distributions, IPTables is controlled through another program or manager such as firewalld, or..."

New page

== Linux ==
Linux typically uses IPTables for its firewall. On most modern Linux distributions, IPTables is controlled through another program or manager such as firewalld, or CSF.

=== Opening a Port ===
To allow a specific port access to your machine, you will (most likely) need to make IPTables ACCEPT traffic meeting the port criteria on the INPUT chain.

Simple IPTables:
{{highlight|lang=terminal|code=
# iptables -A INPUT -p tcp --dport 80 -j ACCEPT
}}

If using Red Hat's firewalld:
{{highlight|lang=terminal|code=
# firewall-cmd --permanent --add-port=80/tcp
# firewall-cmd --permanent --add-service=x
## Reload firewall rules
# firewall-cmd --reload
}}

If using CSF:
{{highlight|lang=terminal|code=
# vi /etc/csf/csf.conf
## Edit 'TCP_IN' to include any TCP traffic IN, or TCP_OUT for traffic out.
## Reload CSF
# csf -r
}}